Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 99 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)
2008 Pontiac Grand Prix Base
Section 99 (Battery, Charging System And Starting System)
2008 Pontiac Grand Prix BaseSECTION Section 99 (Battery, Charging System And Starting System)
WARNING: This page is about a different car, the 2007 Buick LaCrosse and 2007 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Code Index
- Diagnostic Starting Point - Engine Electrical
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- DTC B1327
- DTC B1328
- DTC B1516
- DTC P0560
- DTC P0562
- DTC P0563
- DTC P0615
- DTC P0616
- DTC P0617
- DTC P0621
- DTC P0622
- DTC P0625
- DTC P0626
- DTC P1668
- Symptoms - Engine Electrical
- Battery Inspection/Test
- Battery Charging (3.6L)
- Battery Charging (3.8L)
- Battery Electrical Drain/Parasitic Load Test
- Battery Common Causes of Failure
- Jump Starting in Case of Emergency
- Charging System Test
- Charge Indicator Always On
- Charge Indicator Inoperative
- Generator Noise Diagnosis
- Starter Solenoid Does Not Click
- Starter Solenoid Clicks, Engine Does Not Crank
- Engine Cranks Slowly
- Starter Motor Noise Diagnosis
- Repair Instructions
- Battery Negative Cable Disconnection and Connection (3.8L)
- Battery Negative Cable Disconnection and Connection (3.6L)
- Battery Current Sensor Replacement (3.8L)
- Battery Negative Cable Replacement (3.8L)
- Battery Negative Cable Replacement (3.6L)
- Battery Positive Cable Replacement (3.8L)
- Battery Positive Cable Replacement (3.6L)
- Battery Replacement (3.8L)
- Battery Replacement (3.6L)
- Battery Tray Replacement (3.8L)
- Battery Tray Replacement (3.6L)
- Battery Heat Shield Replacement (3.6L)
- Starter Motor Replacement (3.8L)
- Starter Motor Replacement (3.6L)
- Starter Shield Replacement
- Generator Bracket Replacement
- Generator Brace Replacement (3.8L)
- Generator Replacement (3.8L)
- Generator Replacement (3.6L)
- Description and Operation
- Battery Description and Operation (3.8L)
- Battery Description and Operation (3.6L)
- Charging System Description and Operation
- Electrical Power Management Description and Operation
- Starting System Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.