Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 907 (BODY REAR END)
2004 Oldsmobile Bravada AWD
Section 907 (Body Rear End)
2004 Oldsmobile Bravada AWDSECTION Section 907 (Body Rear End)
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Repair Instructions
- Opening The Lift Gate When There Is An Electrical Failure (Aztec)
- Latch Replacement - Lift Gate (Aztec)
- Latch Replacement - Lift Gate (Rendezvous)
- Trim Panel Replacement - End Gate
- Trim Panel Replacement - Lift Gate (Aztec)
- Trim Panel Replacement - Lift Gate (Rendezvous)
- Water Deflector Replacement - Lift Gate
- Water Deflector Replacement - End Gate
- Pullstrap Replacement - Lift Gate
- Lift Gate Applique Replacement
- Spoiler Replacement - Rear
- Fuel Filler Door Replacement
- Fuel Filler Pocket Replacement (Aztec)
- Fuel Filler Pocket Replacement (Rendezvous)
- Lift Gate Replacement (Rendezvous)
- Lift Gate Replacement (Aztec)
- End Gate Replacement
- Hinge Replacement - End Gate
- Hinge Replacement - Lift Gate (Aztec)
- Hinge Replacement - Lift Gate (Rendezvous)
- Torque Rod Replacement - End Gate
- Strut Replacement - Lift Gate
- Strut Replacement - End Gate
- Lock Cylinder Replacement - End Gate
- Support Cable Replacement - End Gate
- Handle Replacement - End Gate
- Latch Replacement - End Gate
- Wedge Replacement - Lift Gate Body Side
- Wedge Replacement - Lift Gate
- Lock Striker Replacement - End Gate
- Latch Striker Replacement - Lift Gate (Aztec)
- Latch Striker Replacement - Lift Gate (Rendezvous)
- Bellcrank Replacement - End Gate
- Pressure Relief Valve Replacement
- Weatherstrip Replacement - End Gate
- Weatherstrip Replacement - Lift Gate (Aztec)
- Weatherstrip Replacement - Lift Gate (Rendezvous)
- Description and Operation
- Special Tools & Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.