Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data Definitions
Lift Glass Relay: The scan tool displays On/Off. The output of the lift glass release is displayed.
LH Lift Glass Ajar Switch: The scan tool displays Active/Inactive. The state of LH lift glass actuator is displayed.
RH Lift Glass Ajar Switch: The scan tool displays Active/Inactive. The state of the RH lift glass actuator is displayed.
Rear Release Switch: The scan tool displays Active/Inactive. The state of the rear key switch is displayed.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.