Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 907 (BODY REAR END)REPAIR INSTRUCTIONSLIFT GATE REPLACEMENT (AZTEC)INSTALLATION PROCEDURE
2004 Oldsmobile Bravada AWD
Installation Procedure
2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Position the liftgate hinges to the marked location points on the liftgate, with an assistant.
- Install the bolts to the liftgate hinges, with an assistant.
Tighten the liftgate hinge bolts to 33 N.m (28 lb ft).
- Install the liftgate struts. Refer to STRUT REPLACEMENT - LIFT GATE .
- Install the liftgate latch strikers. Refer to LATCH STRIKER REPLACEMENT - LIFT GATE (AZTEK) or LATCH STRIKER REPLACEMENT - LIFT GATE (RENDEZVOUS) .
- Install the liftgate bumper mounting brackets.
- Install the liftgate window. Refer to WINDOW REPLACEMENT -- LIFT GATE (BUICK) or WINDOW REPLACEMENT -- LIFT GATE (PONTIAC) .
- Install the upper and lower liftgate trim panels. Refer to TRIM PANEL REPLACEMENT - LIFT GATE (AZTEK) or TRIM PANEL REPLACEMENT - LIFT GATE (RENDEZVOUS) .
- Adjust the liftgate as required. Refer to HINGE REPLACEMENT - END GATE
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.