Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 675 (BODY REAR END)
2004 Oldsmobile Bravada AWD
Section 675 (Body Rear End)
2004 Oldsmobile Bravada AWDSECTION Section 675 (Body Rear End)
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Repair Instructions
- Fuel Filler Door Release Switch Replacement
- Rear Compartment Lid Switch Replacement
- Compartment Sill Plate Replacement - Rear
- Compartment Trim Panel Replacement - Rear
- Compartment Lid Trim Replacement - Rear
- Compartment Lid Applique Replacement - Rear
- Fuel Filler Door Replacement
- Fuel Filler Door Release Actuator Replacement
- Compartment Lid Adjustment-Rear
- Compartment Lid Replacement - Rear
- Hinge Replacement - Rear Compartment Lid
- Torque Rod Replacement-Rear Compartment Lid
- Torque Rod Adjustment - Rear Compartment Lid
- Lock Cylinder Replacement - Rear Compartment Lid (L47 Engine, 4.0L V8/Aluminum Lid)
- Lock Cylinder Replacement - Rear Compartment Lid (LX5 Engine, 3.5L V6/Steel Lid)
- Handle Replacement - Rear Compartment Lid Interior Release
- Latch Replacement - Rear Compartment Lid (w/o Inside Release Handle)
- Lock Striker Replacement - Rear Compartment Lid
- Pressure Relief Valve Replacement
- Weatherstrip Replacement - Rear Compartment Opening
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.