Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
When a rear compartment lid hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
- Prop open the rear compartment lid in the fully up position.
- Remove the front rear compartment trim panel. Refer to Compartment Trim Panel Replacement - Rear .
- Note the location of the torque rod in the adjustment bracket for reinstallation.
- Use the J 43300
(1) in order to disconnect the torque rod from the adjustment bracket.
- 4.1. Install the J 43300 (1) over the end of the torque rod.
- 4.2. Use a ratchet extension (2) for extra leverage.
- 4.3. Pry rearward, releasing the torque rod from the adjuster bracket.
- 4.4. Carefully move the J 43300 toward the front of the car releasing the pressure on the torque rod.
- Slide the opposite end of torque rod out of the rear compartment hinge.
- Remove the torque rod from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.