SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 675 (BODY REAR END)REPAIR INSTRUCTIONSCOMPARTMENT LID ADJUSTMENT-REARNOTES
2004 Oldsmobile Bravada AWD

Compartment Lid Adjustment-Rear: Notes

2004 Oldsmobile Bravada AWDSECTION Notes
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear shelf trim panel. Refer to TRIM PANEL REPLACEMENT -- REAR WINDOW SHELF .
  2. Perform the front-to-rear lid adjustment at the hinge to rear shelf fasteners.
  3. Loosen the hinge fasteners.
    CAUTION: Refer to FASTENER NOTICE .
  4. Align the lid so as to achieve an equal 3 mm +/-1 mm gap around the entire perimeter of the rear compartment lid.

    Tighten 

    Tighten the bolts to 24 N.m (18 lb ft).

    Fig 1: Locating Hinge Fasteners
    G01804040Courtesy of GENERAL MOTORS CORP.
  5. Up and down adjustment at the front of the rear compartment lid is achieved by turning the adjustment screw (1) located on the hinge arms.

    This procedure is performed from inside the passenger compartment.

    6. Fig 2: Locating Adjustment Screw
    G01804041Courtesy of GENERAL MOTORS CORP.
  6. Adjust the rear compartment lid flush with the rear quarter panels.
  7. Up and down adjustment at the rear of the rear compartment lid is achieved by turning the overslam bumpers in or out.
  8. Adjust the rear compartment lid flush with the rear quarter panels.
  9. Install the rear shelf trim panel. Refer to TRIM PANEL REPLACEMENT -- REAR WINDOW SHELF .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.