Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1293 (ELECTRONIC SUSPENSION SYSTEM - AUTOMATIC LEVEL CONTROL)
2004 Oldsmobile Bravada AWD
Section 1293 (Electronic Suspension System - Automatic Level Control)
2004 Oldsmobile Bravada AWDSECTION Section 1293 (Electronic Suspension System - Automatic Level Control)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Automatic Level Control
- Diagnostic System Check - Automatic Level Control
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- Diagnostic Trouble Code (DTC) List
- DTC C0655
- DTC C0660
- DTC C0711
- Symptoms - Automatic Level Control
- Automatic Level Control Compressor Motor Always On
- Automatic Level Control Compressor Motor Inoperative
- Repair Instructions
- Description and Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.