32 90... Troubleshooting On Steering

2013 Mini Cooper Countryman, Standard TransSECTION 32 90... Troubleshooting On Steering
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Observe front axle troubleshooting in TROUBLE SHOOTING .

STEERING TROUBLESHOOTING

Fault Cause Remedy
Excessive steering wheel play/steering wheel shake. Screws at lower section of steering spindle to steering gear/steering column loose. Replace screws and tighten down (refer to 32 31 070 REMOVING AND INSTALLING/REPLACING LOWER SECTION OF STEERING SPINDLE ).
Bolt connection, universal joint/double joint, to lower section of steering spindle/steering gear/steering column loose. Replace and tighten down bolts (refer to 32 31 211 REPLACING UNIVERSAL JOINT FOR LOWER SECTION OF STEERING SPINDLE ).
Journal of tie rod end deformed. Replace steering gear and tie rod ends. Refer to 32 13 060 REMOVING AND INSTALLING/REPLACING POWER STEERING GEAR  and 32 21 151 REPLACING LEFT OR RIGHT TIE ROD .
Tie rod end worn. Check steering gear rack; if necessary, replace steering gear. Refer to 32 13 060 REMOVING AND INSTALLING/REPLACING POWER STEERING GEAR  and 32 21 151 REPLACING LEFT OR RIGHT TIE ROD .
Check tie rods, replace if necessary. Refer to 32 21 231 REPLACING LEFT OR RIGHT TIE ROD .
Replace tie rod end. Refer to 32 21 151 REPLACING LEFT OR RIGHT TIE ROD .
Steering gear rack damaged. Replace steering gear. Refer to 32 13 060 REMOVING AND INSTALLING/REPLACING POWER STEERING GEAR  and 32 21 151 REPLACING LEFT OR RIGHT TIE ROD .
Refer to TROUBLE SHOOTING .
Steering wheel inclination. Tie rod end worn. Replace tie rod end. Refer to 32 21 151 REPLACING LEFT OR RIGHT TIE ROD .
Front axle alignment incorrectly adjusted. Carry out chassis/wheel alignment check, adjust toe/track if necessary. Refer to 32 00 150 STANDARD CHASSIS/WHEEL ALIGNMENT WITH DIN LOAD  and 32 00 155 CHASSIS/WHEEL ALIGNMENT WITHOUT LOAD .
Refer to TROUBLE SHOOTING .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.