| The sliding door will not open or close automatically with all operations (the power sliding door switch, inner handle, outer handle switch, keyless transmitter) |
- Power sliding door main switch (see POWER SLIDING DOOR SWITCH TEST/REPLACEMENT
)
- Sliding door alignment (see SLIDING DOOR POSITION ADJUSTMENT
)
- Slide motor sensor (see SLIDE MOTOR TEST
)
- Slide motor (see SLIDE MOTOR TEST
)
- Slide motor electromagnetic clutch (see SLIDE MOTOR TEST
)
- Power sliding door control unit (see CONTROL UNIT INPUT TEST
)
- Pinch sensor (see SLIDING DOOR PINCH SENSOR TEST/REPLACEMENT
)
- Fuel fill door switch (Left sliding door only) (see FUEL FILL DOOR SWITCH TEST/REPLACEMENT
)
- Rear junction box (see MICU - REAR JUNCTION BOX INPUT TEST
)
|
| The sliding door will not open or close automatically with the power sliding door switch |
- Power sliding door open/close switch (see POWER SLIDING DOOR SWITCH TEST/REPLACEMENT
)
- Power sliding door control unit (see LEFT POWER SLIDING DOOR
)
- CESS articulated harness (see CESS ARTICULATED HARNESS TEST
)
|
| The sliding door will not open or close automatically with the keyless transmitter |
- Keyless transmitter (see TRANSMITTER TEST
)
- Power sliding door control unit (see LEFT POWER SLIDING DOOR
)
|
| The sliding door will not open or close automatically with the outer handle switch or inner handle |
- Remote control switch 1 (see REMOTE CONTROL SWITCH TEST
)
- Remote control switch 2 (see REMOTE CONTROL SWITCH TEST
)
- Remote control switch 3 (see REMOTE CONTROL SWITCH TEST
)
- Power sliding door control unit (see LEFT POWER SLIDING DOOR
)
- CESS articulated harness (see CESS ARTICULATED HARNESS TEST
)
|
| The sliding door will not open automatically with all operations (the power sliding door switch, inner handle, outer handle switch, keyless transmitter) |
- Release actuator (see RELEASE ACTUATOR TEST
)
- VSA modulator-control unit (see WHEEL SENSOR INSPECTION
)
- Brake pedal position switch (see BRAKE PEDAL POSITION SWITCH TEST
)
- Parking brake switch
- Transmission range switch (see TRANSMISSION RANGE SWITCH TEST
)
- Sliding door alignment (see SLIDING DOOR POSITION ADJUSTMENT
)
- Power sliding door control unit (see LEFT POWER SLIDING DOOR
)
- Power door lock system (see CONTROL UNIT INPUT TEST
)
- PCM (see GENERAL TROUBLESHOOTING INFORMATION
)
- Gauge control module (see GAUGE CONTROL MODULE INPUT TEST
)
- Output shaft speed sensor/Input shaft speed sensor (see DTC P0721: PROBLEM IN OUTPUT SHAFT (COUNTERSHAFT) SPEED SENSOR CIRCUIT
)
- Multiplex integrated control unit (see MULTIPLEX INTEGRATED CONTROL UNIT INPUT TEST
)
|
| The sliding door will not close automatically with all operations (the power sliding door switch, inner handle, outer handle switch, keyless transmitter) |
- Pinch sensor (see SLIDING DOOR PINCH SENSOR TEST/REPLACEMENT
)
- Sliding door alignment (see SLIDING DOOR POSITION ADJUSTMENT
)
- Power sliding door control unit (see LEFT POWER SLIDING DOOR
)
- CESS articulated harness (see CESS ARTICULATED HARNESS TEST
)
|
| The sliding door opens automatically without operation |
- Power sliding door open/close switch (see POWER SLIDING DOOR SWITCH TEST/REPLACEMENT
)
- Keyless transmitter (see TRANSMITTER TEST
) and keyless receiver (built into the power window master switch) (see DOOR MULTIPLEX CONTROL UNIT INPUT TEST
)
- Remote control switch 1 (see REMOTE CONTROL SWITCH TEST
)
- Remote control switch 3 (see REMOTE CONTROL SWITCH TEST
)
- Release actuator (see RELEASE ACTUATOR TEST
)
- Power sliding door control unit (see LEFT POWER SLIDING DOOR
)
- CESS articulated harness (see CESS ARTICULATED HARNESS TEST
)
|
| The sliding door stops before opening all the way |
- Sliding door alignment (see SLIDING DOOR POSITION ADJUSTMENT
)
- Slide motor sensor (see SLIDE MOTOR TEST
)
- Slide motor (see SLIDE MOTOR TEST
)
- Power sliding door control unit (see LEFT POWER SLIDING DOOR
)
- Power sliding door open/close switch (see POWER SLIDING DOOR SWITCH TEST/REPLACEMENT
)
- Keyless transmitter (see TRANSMITTER TEST
) and keyless receiver (built into the power window master switch) (see DOOR MULTIPLEX CONTROL UNIT INPUT TEST
)
- Remote control switches 1, 2 and 3 (see REMOTE CONTROL SWITCH TEST
)
- Output shaft speed sensor/Input shaft speed sensor (see DTC P0721: PROBLEM IN OUTPUT SHAFT (COUNTERSHAFT) SPEED SENSOR CIRCUIT
)
- Transmission range switch (see TRANSMISSION RANGE SWITCH TEST
)
- Gauge control module (see GAUGE CONTROL MODULE INPUT TEST
)
- Multiplex integrated control unit (see MULTIPLEX INTEGRATED CONTROL UNIT INPUT TEST
)
- VSA modulator-control unit (see WHEEL SENSOR INSPECTION
)
- CESS articulated harness (see CESS ARTICULATED HARNESS TEST
)
|
| With the sliding door window closed, the sliding door stops at its interim position |
- Power sliding door window position switch (see WINDOW POSITION SWITCH TEST
)
- Power sliding door control unit (see LEFT POWER SLIDING DOOR
)
- CESS articulated harness (see CESS ARTICULATED HARNESS TEST
)
|
| The sliding door opens half way when the sliding door window is open more than 2.4 in. (60 mm) |
- Power sliding door window position switch (see WINDOW POSITION SWITCH TEST
)
- Power sliding door control unit (see LEFT POWER SLIDING DOOR
)
- CESS articulated harness (see CESS ARTICULATED HARNESS TEST
)
|
| The sliding door opens in any other gear position than park, or opens in neutral with the parking brake released |
- Brake pedal position switch (see BRAKE PEDAL POSITION SWITCH TEST
)
- Parking brake switch (see PARKING BRAKE SWITCH TEST
)
- Transmission range switch (see TRANSMISSION RANGE SWITCH TEST
)
- Power sliding door control unit (see LEFT POWER SLIDING DOOR
)
|
| The vehicle will run over 1.2 mph (2.0 km/h) with the sliding door open |
- VSA modulator-control unit (see WHEEL SENSOR INSPECTION
)
- PCM (see GENERAL TROUBLESHOOTING INFORMATION
)
- Power sliding door control unit (see LEFT POWER SLIDING DOOR
)
|
| The sliding door will close automatically without operation |
- Power sliding door open/close switch (see POWER SLIDING DOOR SWITCH TEST/REPLACEMENT
)
- Keyless transmitter (see TRANSMITTER TEST
) and keyless receiver (built into the power window master switch) (see DOOR MULTIPLEX CONTROL UNIT INPUT TEST
)
- Remote control switch 1 (see REMOTE CONTROL SWITCH TEST
)
- Remote control switch 2 (see REMOTE CONTROL SWITCH TEST
)
- Remote control switch 3 (see REMOTE CONTROL SWITCH TEST
)
- Power sliding door control unit (see
LEFT POWER SLIDING DOOR )
- CESS articulated harness (see CESS ARTICULATED HARNESS TEST
)
|
| The sliding door stops before closing all the way |
- Ratchet switch (see LATCH POSITION SWITCH TEST
)
- Latch position switch (see LATCH POSITION SWITCH TEST
)
- Closer motor (see CLOSER MOTOR TEST
)
- Sliding door alignment (see SLIDING DOOR POSITION ADJUSTMENT
)
- Slide motor sensor (see SLIDE MOTOR TEST
)
- Slide motor (see SLIDE MOTOR TEST
)
- Power sliding door control unit (see LEFT POWER SLIDING DOOR
)
- Power sliding open/close switch (see POWER SLIDING DOOR SWITCH TEST/REPLACEMENT
)
- Keyless transmitter (see TRANSMITTER TEST
) and keyless receiver (built into the power window master switch) (see DOOR MULTIPLEX CONTROL UNIT INPUT TEST
)
- Remote control switch 1 (see REMOTE CONTROL SWITCH TEST
)
- Remote control switch 2 (see REMOTE CONTROL SWITCH TEST
)
- Remote control switch 3 (see REMOTE CONTROL SWITCH TEST
)
- CESS articulated harness (see CESS ARTICULATED HARNESS TEST
)
|