SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 76 (INSTRUMENT PANEL TRIM AND CONSOLE TRIM)REPAIR INSTRUCTIONSINSTRUMENT PANEL COMPARTMENT REPLACEMENT
2008 Pontiac Grand Prix Base

Instrument Panel Compartment Replacement

2008 Pontiac Grand Prix BaseSECTION Instrument Panel Compartment Replacement
WARNING: This page is about a different car, the 2007 Buick LaCrosse and 2007 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Instrument Panel Compartment
GM1553702Courtesy of GENERAL MOTORS CORP.
Instrument Panel Compartment Replacement

Callout Component Name
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .
NOTE: Refer to Fastener Notice .
1 Instrument Panel Compartment Door
Tip: 
  1. Open the door and release the check strap.
  2. Squeeze inward at the top of the check strap and rotate downward to disengage from the instrument panel.
  3. Pull the compartment assembly away from the instrument panel to release from the hinges.
2 Instrument Panel Compartment Door Bushings (Qty: 2)
3 Instrument Panel Storage Compartment Screws (Qty: 4)

Tighten:  Tighten to 2 N.m (18 lb in)
4 Instrument Panel Compartment
Tip:  Partially remove the instrument panel compartment and disconnect the electrical connector from the compartment lamp.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.