Front Floor Console Replacement

2008 Pontiac Grand Prix BaseSECTION Front Floor Console Replacement
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Floor Console
GM1912816Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the left instrument panel lower extension trim panel. Refer to Instrument Panel Lower Extension Trim Panel Replacement - Left Side .
  2. Remove the right instrument panel lower extension trim panel. Refer to Instrument Panel Lower Extension Trim Panel Replacement - Right Side .
  3. Remove the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement .
1 Front Floor Console Screw/Bolt (Qty: 8)
NOTE: Refer to Fastener Notice .

Tighten:  2.5 N.m (22 lb in)

2 Front Floor Console Assembly

Procedure

  1. Disconnect the electrical connections.
  2. When replacing the front floor console assembly, transfer all necessary components.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.