SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 251 (INSTRUMENT PANEL AND CONSOLE TRIM)REPAIR INSTRUCTIONSCONSOLE SHIFT LEVER BEZEL REPLACEMENT
2008 Pontiac Grand Prix Base

Console Shift Lever Bezel Replacement

2008 Pontiac Grand Prix BaseSECTION Console Shift Lever Bezel Replacement
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Console Shift Lever Bezel
GM1912812Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the transmission control lever knob. Refer to Transmission Control Lever Knob Replacement .
1 Console Shift Lever Bezel Screw
NOTE: Refer to Fastener Notice .

Tighten:  2.5 N.m (22 lb in)
2 Console Shift Lever Bezel Assembly

Procedure

  1. Lift the console shift lever bezel straight up disengaging the retainers from the console assembly.
  2. Disconnect the electrical connections.
  3. When replacing the console shift lever bezel, transfer all necessary components.
3 Retainer Clip (Qty: 8)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.