Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 210 (AUTOMATIC TRANSMISSION SERVICING)REMOVAL & INSTALLATIONFORWARD SERVOINSTALLATION
2004 Oldsmobile Bravada RWD
Forward Servo: Installation
2004 Oldsmobile Bravada RWDSECTION Installation
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Install the servo spring. Install the piston assembly.
- Install the O-ring. Install the servo cover. See Figure .
- Install the 3 forward servo cover attaching bolts. Tighten the forward servo cover attaching bolts to specification. See TORQUE SPECIFICATIONS .
- Remove the drain pan from under the forward servo cover.
- Adjust the jackstand to raise the rear of the frame. Install the frame bolts. See appropriate REMOVAL & INSTALLATION article.
- Remove the support from the rear of the frame.
- Install the power steering lines to the right side of the frame.
- Install the engine mount lower nuts. Install the transaxle mount lower nuts.
- Install the power steering gear. See appropriate POWER RACK & PINION article in STEERING.
- Lower the vehicle.
- Fill transaxle with appropriate fluid to proper level. See LUBRICATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.