Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1307 (ANTILOCK BRAKE SYSTEM)REPAIR INSTRUCTIONSDECELERATION SENSOR REPLACEMENTREMOVAL PROCEDURE

2004 Oldsmobile Bravada RWD

Removal Procedure

2004 Oldsmobile Bravada RWDSECTION Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Remove the LH front seat. Refer to SEAT REPLACEMENT - FRONT BUCKET in Seats.
Remove the bolt (1) and the upper deceleration sensor bracket (2).

Fig 1: Removing Bolt And Upper Deceleration Sensor Bracket
Courtesy of GENERAL MOTORS CORP.
Disconnect the deceleration sensor electrical connector.
Remove the two bolts (1) that retain the deceleration sensor (2).
Remove the deceleration sensor (2) from the vehicle.

Fig 2: Removing Deceleration Sensor

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.