Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 479 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)
2004 Oldsmobile Bravada AWD
Section 479 (Supplemental Inflatable Restraint System)
2004 Oldsmobile Bravada AWDSECTION Section 479 (Supplemental Inflatable Restraint System)
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
- Description & Operation
- Component Locations
- System Operation Check
- Air Bag Safety Precautions
- Adjustments
- Disabling & Activating Air Bag System
- Disposal Procedures
- Post-Collision Inspection
- Removal & Installation
- Diagnostics
- Diagnostic Tests
- Sir Diagnostic System Check
- Connector Identification
- Air Bag Warning Light Circuit Malfunction
- DTC B0016,B0017,B0018: Passenger-Side Air Bag Deployment Loop Resistance Low/Resistance High/Short To Ground Or Voltage
- DTC B0022, B0024, B0026: Driver Deployment Loop Resistance Low/Short To Ground Or Voltage/Resistance High
- DTC B0035: Discriminating Sensor Circuit Voltage Low
- DTC B0036: Discriminating Sensor Circuit Voltage High
- DTC B0051: Deployment Commanded
- DTC B0053: Deployment Commanded With Loop Malfunction
- DTC B0090: Air Bag Disable Switch Voltage Out Of Range
- DTC B0091: Air Bag Disable Switch Wrong State
- DTC B1000: SDM Malfunction
- DTC B1001: Option Configuration Error
- Wire Repair
- Torque Specifications
- Wiring Diagrams
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.