Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal & Installation
2004 Oldsmobile Bravada AWDSECTION Removal & Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 7 under DISABLING & ACTIVATING AIR BAG SYSTEM.
- Remove driver seat. Remove carpet retaining sill trim molding. Fold back carpet to access SDM. Remove Connector Position Assurance (CPA) clip from SDM connector. See Fig 1. Disconnect SDM connector. Remove SDM mounting fasteners. Remove SDM.
- To install, reverse removal procedure. Tighten driver seat mounting nuts and SDM fasteners to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ZONE 7 under DISABLING & ACTIVATING AIR BAG SYSTEM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.