SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 469 (ENGINE CONTROLS - REMOVAL & INSTALLATION)IGNITION SYSTEMSSPARK PLUGSINSTALLATION
2004 Oldsmobile Bravada AWD

Spark Plugs: Installation

2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Correctly position the spark plug washer. Inspect the spark plug gap. Adjust the gap as needed. Spark plug gap should be 0.060" (1.524 mm). Hand start the spark plug in the corresponding cylinder. Tighten the spark plug to specification. See TORQUE SPECIFICATIONS . Install the spark plug wire.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.