Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Injection Control Module: Installation
2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Do not knock off the insulators when installing the fuel injector control module to the bracket.
- Install the insulators to the control module. Install the control module. Install by hand the fuel lines and bolts with NEW washers to the control module. Install the control module bolts and tighten to specification. See TORQUE SPECIFICATIONS .
- Connect the control module electrical connectors. Tighten the fuel line bolts to specification. Install the air cleaner outlet duct. See AIR CLEANER OUTLET DUCT under AIR INDUCTION SYSTEMS.
- Install the positive battery cable. Tighten the positive battery cable bolt to specification. Snap the positive battery cable cap closed. Connect the negative battery cables. Tighten battery cable bolts to specification. Install the fuel fill cap.
- Depress the fuel manager primer button 30 times.
- Start the engine. If the engine stalls, repeat step 4. Inspect for fuel leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.