Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electronic Ignition Module: Installation
2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install gasket to ignition module. Apply dielectric compound to spark plug boots and ensure no corrosion is present. Install ignition module housing assembly with spark boots into position, then install bolts. Tighten bolts to specification. See TORQUE SPECIFICATIONS .
- Connect EI module harness connector. Push connector until the lock position is felt, then pull back to confirm engagement. Install upper intake manifold. See INTAKE MANIFOLD & SPACER (3.0L) under AIR INDUCTION SYSTEMS.
- Connect negative battery cable. Tighten negative battery terminal bolt to specification. Reset all preset radio stations and set clock to correct time.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.