Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 364 (SERVICING - A/T (VT25-E))ADJUSTMENTSTRANSAXLE RANGE SWITCH
2004 Oldsmobile Bravada AWD
Transaxle Range Switch
2004 Oldsmobile Bravada AWDSECTION Transaxle Range Switch
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Shift transaxle into Neutral position.
- Using Fascia Retainer Remover (J-36346), remove control cable assembly from transaxle range switch lever. See Fig 1 .
- Remove transaxle range switch lever nut and lever. See Fig 2 .
- Loosen transaxle range switch bolts.
- Insert Transaxle Range Switch Tool (J-44810) as shown and rotate switch until tool drops into position. See Fig 3 . Transaxle range switch tool is aligned when pin on tool drops into hole on transaxle range switch.
- Tighten transaxle range switch bolts to specification. Remove alignment tool. Install transaxle range switch lever and nut, then tighten to specification. See TORQUE SPECIFICATIONS .
- Remove the alignment tool.
- Install the transaxle range switch lever and nut. See Fig 2 . Tighten the transaxle range switch lever nut to specification. See TORQUE SPECIFICATIONS .
- Install control cable assembly to transaxle range switch lever. See Fig 1 .
- After adjusting switch, verify engine starts only in Park or Neutral. If engine starts in any other position, readjust switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.