Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 364 (SERVICING - A/T (VT25-E))TORQUE SPECIFICATIONS
2004 Oldsmobile Bravada AWD
Torque Specifications
2004 Oldsmobile Bravada AWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Battery Terminal Bolt | 13 (17) |
| Battery Tray Bracket Screw | 12 (16) |
| Transaxle Cooler Line Fitting | 12 (16) |
| Transaxle Lower Tube Assembly | 12 (16) |
| Transaxle Range Switch Lever Nut | 12 (16) |
| INCH Lbs. (N.m) | |
| Battery Cooling Box Bolts | 133 (15) |
| Battery Cooling Box Cover Screw | 18 (2) |
| Battery Cooling Box Side Support Screw | 89 (10) |
| Battery Hold-Down Screw | 133 (15) |
| Center Console Screws | 22 (2.5) |
| Console Screws | 22 (2.5) |
| Control Valve Body Assembly-To-Transaxle Case Assembly Bolt | 71 (8) |
| Cup Holder Screw | 22 (2.5) |
| Drive Pulley Cover Bolt | 97 (11) |
| Front Fascia-To-Lower Front Fender Bolt | 80 (9) |
| Harness Connector/Retainer Screw | 35 (4) |
| Headlight Bracket-To-Structure Bolt | 89 (10) |
| Input & Output Speed Sensor Bolt | 97 (11) |
| Manual Shaft Detent Assembly | 97 (11) |
| Transaxle Oil Cooler Line Nut | 71 (8) |
| Transaxle Lower Tube Plug | 97 (11) |
| Transaxle Range Switch Bolts | 97 (11) |
| Underhood Fuse Box Terminal Nut | 89 (10) |
| Underhood Fuse Box Connector Bolt | 35 (4) |
| Valve Body Cover Bolt | 97 (11) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.