Torque Specifications

2004 Oldsmobile Bravada AWDSECTION Torque Specifications
WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2003 Pontiac Montana, 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Pontiac Aztek, and 2003 Oldsmobile Silhouette. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Case Cover Bolt (1)
Bolt No. 3 18 (25)
Bolts No. 1, 2 & 4 (2)
Case Extension Bolt 26 (35)
Case Side Cover Bolt (3) 18 (25)
Control Valve Body Bolt (4)
Bolts No. 1-5 (2)
Bolt No. 6 12 (16)
Bolt No. 7 18 (25)
Bolt No. 8 (5)
Bolt No. 9 (2)
Drive Sprocket Support Bolt 18 (25)
Manual Shaft-To-Detent Lever Nut 24 (32)
Oil Cooler Fitting 28 (38)
Shift Shaft Nut 23 (31)
Transfer Case-To-Transaxle Bolt
Bolts No. 1 & 2 (6)
Bolt No. 3 (7)
Bolts No. 4 & 5 30 (40)
Transfer Case Lower Brace-To-Transaxle Bolt 23 (31)
Transfer Case Lower Brace-To-Transaxle Lower Bolt 42 (56)
Transfer Case Side Brace Bolt 23 (31)
2-1 Manual Band Servo Cover Bolt 18 (25)
INCH Lbs. (N.m) 
Accumulator Bolt 106 (12)
Accumulator Cover-To-Case Bolt 106 (12)
Forward Band Servo Cover Bolt 106 (12)
Manual Valve Shift Detent Bolt 106 (12)
Oil Pan Bolt 120 (14)
Oil Pressure Test Plug 106 (12)
Oil Pump Bolt (8)
Bolt No. 1 71 (8)
Bolts No. 2 & 3 106 (12)
Vehicle Speed Sensor Bolt 106 (12)
(1) See Figure.
(2) Tighten bolts to 106 INCH lbs. (12 N.m).
(3) See Figure.
(4) See VALVE BODY BOLT SPECIFICATIONS  table.
(5) Tighten bolts to 71 INCH lbs. (8 N.m).
(6) Tighten bolts in 2 passes, 1st pass 26 ft. lbs. (35 N.m) and 2nd pass an additional 160 degrees.
(7) Tighten bolt in 2 passes, 1st pass 26 ft. lbs. (35 N.m) and 2nd pass an additional 70 degrees.
(8) See OIL PUMP BOLT SPECIFICATIONS  table.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.