Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 31 (HVAC SYSTEMS - MANUAL)REMOVAL & INSTALLATIONCOMPRESSORINSTALLATION
2004 Oldsmobile Bravada AWD
Removal & Installation: Compressor: Installation
2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- Add 2 ounces of PAG oil to the compressor crankcase. Install the compressor drain plug. Tighten the compressor drain plug to specification. See TORQUE SPECIFICATIONS . Install the A/C compressor. Install the A/C compressor front nuts. Tighten the nuts to specification. Install the A/C compressor rear bolts. Tighten bolts to specification.
- Install the new sealing washers. Install the A/C compressor hose assembly to the rear of the A/C compressor. Install the A/C compressor hose nut to the compressor. Tighten the nut to specification. Connect the electrical connector to the A/C compressor.
- Install the lower air deflector. Install the right side engine splash shield. Lower the vehicle. Install the accessory drive belt. Install the cross vehicle brace. Evacuate and recharge the A/C system. See RECOVERY, EVACUATION & RECHARGING in GENERAL SERVICING PROCEDURES article in GENERAL SERVICING.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.