Removal Procedure

2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement .
  2. Remove the instrument panel (I/P) storage compartment. Refer to Instrument Panel Storage Compartment Replacement .
  3. Remove the center trim bezel. Refer to Instrument Panel Accessory Bezel Replacement .
  4. Fig 1: View Of Electrical Connectors & HVAC Control Module
    GM1644394Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connectors from the HVAC control module.
  6. Disconnect the remaining electrical connectors from the center trim bezel.
  7. Fig 2: HVAC Control Module & Center Trim Bezel
    GM1644589Courtesy of GENERAL MOTORS CORP.
  8. Remove the HVAC control module screws from the center trim bezel.
  9. Remove the HVAC control module from the center trim bezel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.