Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (ANALOG INSTRUMENT PANELS)SELF-DIAGNOSTIC SYSTEMDIAGNOSTIC TROUBLE CODE DEFINITIONS
2004 Oldsmobile Bravada AWD
Diagnostic Trouble Code Definitions
2004 Oldsmobile Bravada AWDSECTION Diagnostic Trouble Code Definitions
WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC TROUBLE CODE DEFINITIONS
| DTC (1) | Definition | Perform Test | ||
|---|---|---|---|---|
| B0160 | Ambient Air Temperature Sensor Circuit Low | B0160 | ||
| B0162 | Temperature Sensor Circuit Open | B0162 | ||
| B0931 | Compass Sensor Circuit Malfunction | B0931 | ||
| B2823 | Trip Odometer Reset Switch Circuit Low | B2823 | ||
| B2964 | Incorrect Ignition Lock Cylinder Signal Voltage Input | B2964 | ||
| C1245 | Tire Inflation Monitor Circuit Low | C1245 | ||
| P0462 | Fuel Level Signal Voltage Low | P0462 | ||
| P0463 | Fuel Level Signal Voltage High | P0463 | ||
| P1189 | Oil Pressure Switch Signal Voltage Is High | P1189 | ||
|
||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.