Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Using Radio Data System (RDS) Equipped Radio
2004 Oldsmobile Bravada AWDSECTION Using Radio Data System (RDS) Equipped Radio
WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch to RUN or ACCY position. Ensure radio is off. Press and hold DISP button on radio for at least 5 seconds until SETTINGS message is displayed.
- Press SEEK button up or down to scroll through main menu. Scroll until TIRE MON is displayed. Press PREV or NEXT button to display sub-menu. RESET will be displayed. Press DISP button to reset. Chime will be heard and DONE will be displayed for one second.
- After reset has been accomplished, scroll main menu until EXIT is displayed. Press DISP button to exit programming. Chime will verify exit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.