Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1346 (AUTOMATIC TRANSMISSION - MU4 (INTRODUCTION, SERVICE & REPLACEMENT))REPAIR INSTRUCTIONSVEHICLE SPEED SENSOR (VSS) REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada AWD
Installation Procedure
2004 Oldsmobile Bravada AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Apply J 36850 to the VSS O-ring.
- Install the Vehicle Speed Sensor (VSS) into the transaxle case. Secure the VSS (2) with the retaining bolt (1).
Tighten: Tighten the VSS speed sensor (VSS) bolt to 6 N.m (53 lb in).
- Connect the VSS electrical connector.
- Connect the negative (-) battery cable.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.