Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1211 (MANUAL TRANSMISSION - MM6/M12)REPAIR INSTRUCTIONSSHIFT ROD REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada AWD
Removal Procedure
2004 Oldsmobile Bravada AWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the shift control assembly. Refer to SHIFT CONTROL ASSEMBLY REPLACEMENT .
- Remove the driveline support assembly, the transmission and the differential from the vehicle, then separate the transmission from the driveline support assembly. Refer to TRANSMISSION REPLACEMENT .
- Slide the transmission shift rod toward the transmission until the transmission shift shaft seats in the rear-most detent position.
(Placing the shift rod close to the transmission housing provides additional support for the transmission shift shaft.)
- Using a drift or punch, remove the roll pin (1) retaining the transmission shift rod to the transmission shift shaft.
- Remove the transmission shift rod from the transmission shift shaft.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.