Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1211 (MANUAL TRANSMISSION - MM6/M12)
2004 Oldsmobile Bravada AWD
Section 1211 (Manual Transmission - Mm6/M12)
2004 Oldsmobile Bravada AWDSECTION Section 1211 (Manual Transmission - Mm6/M12)
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Visual Identification
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Manual Transmission
- Diagnostic System Check - Manual Transmission
- Transmission Scan Tool Data List
- Transmission Scan Tool Data Definitions
- Diagnostic Trouble Code (DTC) Type Definitions
- DTC P0500: Vehicle Speed Signal
- DTC P0704: Vehicle Speed Changes Without Clutch Transitions
- DTC P0712: Transmission Fluid Temperature High
- DTC P0713: Transmission Fluid Temperature Low
- DTC P0801: Driver State Mismatch
- DTC P0803: Internal Fault Detection Circuit
- DTC P0804: Internal Fault Detection Circuit
- Symptoms - Manual Transmission
- Transmission Shifts Hard
- Gear Clash When Shifting Gears
- Transmission Noisy
- Transmission Jumps Out of Gear
- Transmission Does Not Shift Into One Gear
- Transmission Locked in One Gear
- Clunk on Acceleration or Deceleration
- Transmission Fluid Leak Diagnosis
- Repair Instructions
- Transmission Fluid Level Inspection
- Shift Control Assembly Replacement
- Shift Control Boot Replacement
- Shift Control Shift Closeout Boot Replacement
- Shift Control Knob Replacement
- Shift Rod Replacement
- Shift Linkage Adjustment
- Backup Lamp Switch Replacement
- Transmission Fluid Temperature (TFT) Sensor Replacement (Export)
- Reverse Lockout Solenoid Replacement
- Gear Select/Skip Shift Solenoid Replacement
- Transmission Fluid Replacement
- Transmission Vent Tube Replacement
- Transmission Replacement
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.