Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 121 (ENGINE CONTROLS - REMOVAL & INSTALLATION, OVERHAUL)FUEL SYSTEMSFUEL TANKINSTALLATION
2004 Oldsmobile Bravada AWD
Fuel Tank: Installation
2004 Oldsmobile Bravada AWDSECTION Installation
WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- With the aid of an assistant, raise the fuel tank to the vehicle. Connect wiring harness connectors and EVAP pipes as necessary.
- Install the fuel tank retaining straps. Tighten the strap bolts to specification. See TORQUE SPECIFICATIONS . Connect the wiring harness into the multiway rear body connector. Connect the EVAP vapor pipe to the EVAP canister.
- Connect the fuel filler hose to the fuel tank. Tighten the fuel filler hose clamp to specification. Install the rubber exhaust hangers. Install the exhaust heat shield. Tighten the exhaust shield bolt/nuts to specification. Connect the fuel return pipe and fuel filter quick-connect fittings. Lower the vehicle. Refill the fuel tank. Install the fuel filler cap.
- Inspect for leaks by using the following procedure.
- Turn ignition on for 2 seconds.
- Turn ignition off for 10 seconds.
- Turn ignition on.
- Check for fuel leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.