Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Injector Control Module Description: Notes
The fuel injector control module (FICM) is a non-flashable control module that is not capable of serial data communication.
The FICM performs the following tasks:
- Operates the CNG injectors based upon the powertrain control module (PCM) injector signals
- Supplies the reference, ground and signal circuits to the fuel rail temperature (FRT), fuel tank pressure (FTP) and fuel tank temperature (FTT) sensors
- Communicates the FRT, FTP and FTT sensor values to the PCM using a single dedicated PWM circuit
- Communicates FICM diagnostic information to the PCM using a dedicated PWM circuit
The PCM controls fuel delivery and determines fuel system operation. The PCM monitors various engine and vehicle functions to provide the correct amount of CNG or gasoline fuel under all operating conditions. The fuel injector control circuits, an AF enable circuit and 2 PWM communication circuits connect the PCM to the FICM. The PCM is not capable of operating the high current CNG fuel injectors. The PCM injector pulse width signals are received by the FICM and duplicate pulse width signals are generated by the FICM in order to operate the CNG injectors. The Bi-fuel vehicles utilize underhood mounted injector relays. When operating on gasoline the injector relays are energized allowing the PCM injector pulse width to go directly to the gasoline injectors.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.