Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2507 (REAR AXLE - REPAIR)FINAL DRIVE33 60 003 REMOVING AND INSTALLING/REPLACING CONTROL UNIT FOR DYNAMIC PERFORMANCE CONTROLNOTES
2013 Mini Cooper Countryman, Standard Trans
33 60 003 Removing and installing/replacing control unit for Dynamic Performance Control: Notes
2013 Mini Cooper Countryman, Standard TransSECTION Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Remove control unit only after being prompted to do so by diagnosis system.
Necessary preliminary tasks:
- Replacement only: Start INITIAL OPERATION and follow instructions on screen.
- Remove BATTERY COVER .
Disconnect plug connection (1).
Release nuts (2) and remove control unit (3).
Installation:
Tightening torque 33 11 7AZ .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.