Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2327 (FRONT AXLE - REPAIR)TROUBLESHOOTING31 90... FRONT AXLE TROUBLESHOOTING
2013 Mini Cooper Countryman, Standard Trans
31 90... Front Axle Troubleshooting
2013 Mini Cooper Countryman, Standard TransSECTION 31 90... Front Axle Troubleshooting
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Follow 31 90... TROUBLESHOOTING SHOCK ABSORBER .
TROUBLESHOOTING CHART
| Fault | Cause | Remedy |
|---|---|---|
| Grinding noise (or humming)
IMPORTANT:
Tire rolling noises can sound very similar to wheel bearing noises. Test: Drive car
|
|
|
| Vibration | Wheel imbalance | Balance wheels |
| Radial/lateral rim runout | Check rims, replace if necessary | |
| Radial tire runout | Match or replace tires | |
| Steering-wheel shake | Wheel imbalance | Balance wheels |
| Radial/lateral rim runout | Check rims, replace if necessary | |
| Rubber mount of control arm faulty | Replace control arms | |
| Ball joint in control arm worn | Replace control arms | |
| Rubber mount of tension strut faulty | Replace rubber mounts on both tension struts | |
| Ball joint on tension strut worn | Replace both tension struts | |
| Refer to TROUBLESHOOTING for steering. | ||
| Excessive steering wheel play/steering wheel inclination | Refer to TROUBLESHOOTING . | |
| Rattling noise | Bolts for reinforcement strut loose | Tighten down bolts |
| Bolt for V-strut loose | Tighten down bolts | |
| Bolt connection for diagonal struts loose | Tighten down bolts | |
| Bolts for reinforcement plate loose | Tighten down bolts | |
| Bolts for front axle carrier to engine carrier loose | Replace bolts | |
| Bolt for spring strut to swivel bearing loose | Replace bolt & nut | |
| Ball joint in control arm worn | Replace control arms | |
| Ball joint on tension strut worn | Replace both tension struts | |
| Rubber mounts for stabilizer bar bracket faulty | Replace both rubber mounts of stabilizer bar bracket | |
| Ball joints on stabilizer link(s) worn | Replace both stabilizer links | |
| Excessive tire wear | Front or rear axle alignment incorrectly adjusted | Check suspension components for damage; if necessary, carry out chassis/wheel alignment check |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.