Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
11 9 470 Support
Minimum set: Mechanical tools
Note: For installing/removing bearing bracket (Camcarrier)
Engine: N62, N62TU, N73
SI number: 1 14 01(766)
Order number: 11 9 470
Support
Consisting of:
1 = 11 9 471 Base plate
2 = 11 9 472 Shaped section
3 = 11 9 473 Knurled nut
4 = 11 9 474 Retaining screws (2 x)
5 = 11 9 475 Guide bushes (2 x)
6 = 11 9 476 Shaped section
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.