Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2224 (ENGINE - SPECIAL TOOLS)
2013 Mini Cooper Countryman, Standard Trans
Section 2224 (Engine - Special Tools)
2013 Mini Cooper Countryman, Standard TransSECTION Section 2224 (Engine - Special Tools)
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
- Engine
- 11 0 000 Engine lifter for removing and installing engines
- 11 0 020 Engine hoist for removing and installing engines
- 11 0 240 Coupling
- 11 2 000 Puller
- 11 3 460 Protractor
- 11 4 190 1/4" extension piece
- 11 4 490 Removal and installation kit
- 11 5 430 Piston ring pliers
- 11 5 450 Mounting sleeve
- 11 5 461 Installation holder
- 11 5 462 Installation pliers
- 11 5 463 Installation drift
- 11 5 464 Removal pliers
- 11 7 030 Socket wrench socket WAF 22
- 11 9 000 Cylinder head expander tool
- 11 9 150 Special wrench
- 11 9 190 Plug mandrel
- 11 9 410 Puller
- 11 9 420 Installer
- 11 9 450 Counter holder w/ socket & pointer
- 11 9 460 Gauge
- 11 9 470 Support
- 11 9 480 Lever
- 11 9 490 Holding sleeve
- 11 9 811 Holder
- 11 9 812 Screw
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.