Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2125 (FRONT AXLE - REPAIR)
2013 Mini Cooper Countryman, Standard Trans
Section 2125 (Front Axle - Repair)
2013 Mini Cooper Countryman, Standard TransSECTION Section 2125 (Front Axle - Repair)
WARNING: This page is about a different car, the 2010 BMW 535i, 2009 BMW 535i, and 2008 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.
- General
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety instructions for handling oil
- 00...... Raising vehicle with trolley jack
- 31.... Front axle overview
- 31.... Layout of spring strut shock absorber
- 31 00... Front axle + steering: wheel/chassis alignment check must be carried out after the following work
- 31 00... Information on replacing shock absorbers
- 31 00... Instructions (chassis components made of aluminium)
- 31 00... Instructions (damage to suspension)
- 31 00 Mobile table lift
- 31 00... Notes on repairing threads
- Front Axle Suspension
- Front Sub-Frame
- Struts With Rubber Mounts
- 31 12 000 Removing and installing/replacing left or right control arm
- 31 12 003 Removing and installing / replacing top right wishbone
- 31 12 024 Replace wheel control joint in wishbone (all-wheel drive vehicle)
- 31 12 050 Removing and installing/replacing left or right trailing link
- 31 12 080 Removing and installing/replacing both trailing links
- 31 12 138 Replacing rubber mounts on both trailing links
- Wheel Bearings And Stub Axle
- Spring Strut
- Spring With Suspension
- Stabilizer Bar
- 31 35 000 Removing and installing/replacing front stabilizer
- 31 35 005 Removing and installing/replacing push rod (stabilizer link) for left/right stabilizer
- 31 35 007 Removing and installing/replacing holder for left or right push rod/stabilizer
- 31 35 021 Replacing rubber mounts of stabilizer retaining fixture on front axle carrier
- Troubleshooting
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.