Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1569 (INTEGRATED SUSPENSION SYSTEMS - REPAIR)22 PUMP ASSEMBLY WITH CONNECTOR37 12 ... REPLACING LOWER VENT LINE
2013 Mini Cooper Countryman, Standard Trans
37 12 ... Replacing Lower Vent Line
2013 Mini Cooper Countryman, Standard TransSECTION 37 12 ... Replacing Lower Vent Line
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Risk of damage!
Extreme cleanliness must be ensured in the connection area of the vent lines during removal and installation. Even the smallest of dirt particles can cause leakage in the air spring system.
Extreme cleanliness must be ensured in the connection area of the vent lines during removal and installation. Even the smallest of dirt particles can cause leakage in the air spring system.
Necessary preliminary tasks:
- Remove front right wheel arch cover (rear section). See 51 71 039 REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT WHEEL ARCH COVER (REAR SECTION) .
Disconnect quick-connect couplings (1, 3).
Seal connections of air supply unit supply line and upper vent line with sealing plugs.
Unclip lower vent line (2) and feed out.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.