Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHONDA2002CIVIC SIREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 188 (POWER TAILGATE)DRIVE UNIT REPLACEMENT

2002 Honda Civic Si

Drive Unit Replacement

2002 Honda Civic SiSECTION Drive Unit Replacement

WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.

Remove the left rear pillar (see TRIM REMOVAL/INSTALLATION - PILLAR AREAS ) and headliner (see HEADLINER REMOVAL/INSTALLATION ).
Disconnect the 2P and 8P connectors (A) from the drive unit (B).

Fig 1: Disconnecting 2P And 8P Connectors From Drive Unit
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Close the tailgate, then remove the nut and support strut (C).
Remove the mounting bolts and drive unit (A).

Fig 2: Removing Mounting Bolts And Drive Unit
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install in the reverse order of removal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.