Vanity Mirror Light Test/Replacement

2002 Honda Civic SiSECTION Vanity Mirror Light Test/Replacement
WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the sunvisor (see HEADLINER REMOVAL/INSTALLATION ).
  2. Disconnect the 2P connector (A) from the sunvisor (B).

    Vanity Mirror Light: 2 W 

    Fig 1: Removing Vanity Mirror Light
    G03706733Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the No. 1 and No. 2 terminals.
    • With the vanity mirror cover (C) opened, there should be continuity.
    • With the vanity mirror cover (C) closed, there should be no continuity.
  4. If the continuity check is not as specified, check the bulb (D). If the bulb is OK, replace the sunvisor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.