Door Key Cylinder Switch Test

2002 Honda Civic SiSECTION Door Key Cylinder Switch Test
WARNING: This page is about a different car, the 2006 Honda Odyssey and 2005 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 3P connector from the key cylinder switch.
    Fig 1: Disconnecting 3P Connector From Key Cylinder Switch
    G03706656Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminals.
    • There should be continuity between the No. 2 and No. 3 terminals when the door key cylinder switch is in LOCK position. (Except VAN and LX models)
    • There should be no continuity between the No. 2 and No. 3 terminals when the door key cylinder switch is in the neutral or UNLOCK position. (Except VAN and LX models)
    • There should be continuity between the No. 1 and No. 2 terminals when the door key cylinder switch is in UNLOCK position.
    • There should be no continuity between the No. 1 and No. 2 terminals when the door key cylinder switch is in the neutral or LOCK position.
  4. If the continuity is not as specified, replace the door key cylinder assembly (see FRONT DOOR OUTER HANDLE REPLACEMENT ).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.