Front Door Panel Removal/Installation

Special Tools Required 

• KTC trim tool set SOJATP2014
• Trim pad remover, Snap-on A 177A or equivalent, commercially available

1. Lower the glass fully.
2. Using the appropriate trim tool, pry out on the rear portion of the cover (A) to release the hooks (B, C), then remove the cover and the screws securing the inner handle (D).
   Fig 1: Removing Cover And Inner Handle Screws

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the power window switch panel (A).
   Fig 2: Removing Power Window Switch Panel (Driver's)

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the door panel (A) with as little bending as possible to avoid creasing or breaking it.
   • -1 Remove the screws (B).
   • -2 Use a commercially available trim pad remover (C) to detach the clips (D).
   • -3 Starting at the rear, pull the door panel upward, then release the lock knob (E).
     NOTE: To avoid damaging components inside the door, do not use excessive force when raising the panel.
   Fig 3: Removing Door Panel (2 Of 2)

   Courtesy of AMERICAN HONDA MOTOR CO., INC.