SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025TRAVERSE HIGH COUNTRY, FWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASDRIVER ASSISTANCE SYSTEMS - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSIMAGE PROCESSING MODULE REPLACEMENTINSTALLATION PROCEDURE
2025 Chevrolet Traverse High Country, FWD

Installation Procedure

2025 Chevrolet Traverse High Country, FWDSECTION Installation Procedure
  1. GM6397873Courtesy of GENERAL MOTORS COMPANY

    Image Processing Module (2) - Install

    2. CAUTION:

    Fastener Caution

  2. Image Processing Module Nut (1) - Install and tighten [3x] - Fastener Specifications
  3. Connect the electrical connectors.
  4. GM6399525Courtesy of GENERAL MOTORS COMPANY

    Quarter Lower Rear Trim Panel - Left Side (1) - Install

  5. Connect the electrical connectors.
  6. GM4755353Courtesy of GENERAL MOTORS COMPANY

    Rear End Trim Finish Panel (1) - Install

  7. GM6389419Courtesy of GENERAL MOTORS COMPANY

    Liftgate Lock Striker Cover (1) - Install

  8. GM6399531Courtesy of GENERAL MOTORS COMPANY

    Rear Compartment Floor Stowage Compartment Divider (2) - Install

  9. Rear Compartment Floor Stowage Compartment Divider Retainer (1) - Install and tighten [4x] - Fastener Specifications
  10. GM6399529Courtesy of GENERAL MOTORS COMPANY

    Rear Compartment Floor Panel Front Trim (1) - Install

  11. GM6399524Courtesy of GENERAL MOTORS COMPANY

    Load Floor Trim Panel (1) - Install

  12. GM6399467Courtesy of GENERAL MOTORS COMPANY

    Cargo Tie Down Loop (3) - Install [2x]

  13. Cargo Tie Down Loop Bolt (2) - Install and tighten [2x] - Fastener Specifications
  14. Cargo Tie Down Loop Trim Cover (1) - Install [2x]
  15. GM6399466Courtesy of GENERAL MOTORS COMPANY

    Body Rear Corner Upper Garnish Molding (3) - Install

  16. Body Rear Corner Upper Garnish Molding Bolt (2) - Install and tighten - Fastener Specifications
  17. Body Rear Corner Upper Garnish Molding Cap (1) - Install
  18. GM6399528Courtesy of GENERAL MOTORS COMPANY

    Quarter Upper Trim Panel (3) - Install

  19. Quarter Upper Trim Panel Bolt (2) - Install and tighten - Fastener Specifications
  20. Quarter Upper Trim Panel Bolt Cap (1) - Install
  21. GM4772715Courtesy of GENERAL MOTORS COMPANY

    Rear Side Door Sill Garnish Molding (1) - Install

  22. Enable the SIR System. SIR Disabling and Enabling
  23. Perform the necessary programming and setup procedure:Control Module References
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.