Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Rear Compartment Lift Window (1) - Install
With aid of assistance, lift and slid the rear compartment lift window (1) to the right and onto the hinge pins (2).
Install the liftgate hinge pin retainers (1).
Install the rear compartment lift window strut (1) at window [2x].
Rear Window Defroster Electrical Connector (2) - Connect [2x]
- Rear Window Defroster Electrical Connector Trim Cover (1) - Install [2x]
Rear End Spoiler (2) - Install
- Rear End Spoiler Bolt (1) - Install and tighten [11x] - Fastener Specifications
Rear End Spoiler Bolt (1) - Install and tighten [4x] - Fastener Specifications
- Close the rear compartment lid.
Open the liftgate.
- Connect all electrical connectors.
- Rear Window Washer Nozzle Hose Extension - Connect
- Connect the liftgate upper panel grommet.
- Engage the retaining clips (2) at the rear underside of the headlining trim panel (1).
- Headlining Trim Panel (1) - Install
Body Rear Corner Upper Garnish Molding (1) - Reposition
Body Rear Corner Upper Garnish Molding Bolt (1) - Install and tighten - Fastener Specifications
Body Side Rear Window Garnish Molding Tether Retaining Clip (2) - Install
- Body Side Rear Window Garnish Molding Bolt (1) - Install and tighten - Fastener Specifications
- NOTE:
Position the body side rear window garnish molding tether in the same position as before molding removal.
Body Side Rear Window Garnish Molding (1) - Install
Body Rear Corner Upper Garnish Molding (1) - Reposition
Body Rear Corner Upper Garnish Molding Bolt (1) - Install and tighten - Fastener Specifications
Body Side Rear Window Garnish Molding Tether Retaining Clip (2) - Install
- Body Side Rear Window Garnish Molding Bolt (1) - Install and tighten - Fastener Specifications
Body Side Rear Window Garnish Molding (1) - Install
Liftgate Weatherstrip (1) - Reposition
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.