Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Front Side Door Window Regulator (1) - Install
- CAUTION:
Refer to Fastener Caution .
Front Side Door Window Regulator Nut (1) - Install and tighten [5x] - Fastener Specifications
Connect the electrical connector.
- Place the window regulator sash retainer (1) in the halfway up position.
- Remove the tape and position the window down to the regulator sash and secure.
- NOTE:
When reinstalling water deflector ensure integral locators are installed properly and that water deflector is secured and leakproof.
Route front side door inside handle cable through hole in deflector (1).
- Front Side Door Water Deflector (1) - Install
Front Side Door Pull Handle Bracket (2) - Install
- Front Side Door Armrest Bracket Bolt (1) - Install and tighten [2x] - Fastener Specifications
- Front Side Door Trim - Install - Front Side Door Trim Removal and Installation
- Enable the SIR System. SIR Disabling and Enabling
- Ensure the window system operates properly.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.