Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Electronic Suspension Control Module (2) - Install
- Electronic Suspension Control Module Bracket Nut (1) - Install and tighten [4x] - Fastener Specifications
Install the electronic suspension control module bracket (1) in to the keyhole slot at the frame.
- NOTE:
- The electronic suspension control module bracket nuts and studs are part of the bracket.
- Turn the stud left to tighten.
Tighten the 2 electronic suspension control module bracket studs (2). Fastener Specifications
- Electronic Suspension Control Module Bracket Bolt (1) - Install and tighten [2x] - Fastener Specifications
Connect the electronic suspension control module wire harness connector (2).
- If equipped, connect the trailer brake control module wire harness connector (1).
- Spare Wheel - Install
- Remove the support and lower the vehicle.
- After installation, program the module. Control Module References
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.