Windows and Glass: Specifications

2013 Volvo XC60 AWD L6-3.2L VIN 95 B6324S5SECTION Specifications





Tightening torque

Torque: Air conditioning high-pressure switch (steel), 8 Nm

Torque: air conditioning clutch drive plate, 28 Nm

Torque: Rear view mirror to front door , 8 Nm

Torque: Load limiter to seat, 40 Nm

Torque: Seat belt tensioner lap to seat, 40 Nm

Torque: Safety belt retractor rear to body, 40 Nm

Torque: Safety belt retractor front to body, 40 Nm

Torque: Clips refrigerant pipe to bodywork, 6 Nm

Torque: Front seat to body, 40 Nm

Torque: Glass sun roof to sun roof module (glass), 3 Nm

Torque: Inflatable curtain to the body, 8 Nm

Torque: Impact sensor to body, 6 Nm

Torque: Air bag to seat (SIPS), 7 Nm

Torque: Refrigerant pipe to expansion valve , 4.5 Nm

Torque: Buckle safety belt to body, 40 Nm

Torque: Buckle safety belt to seat , 45 Nm

Torque: Door lock cylinder to external handle (vehicles with keyless vehicle module (KVM)), 4 Nm

Torque: Door lock cylinder to external handle (vehicles without keyless vehicle module (KVM)), 3 Nm

Torque: Door latch to door, 8 Nm

Torque: Needle valve, 6 Nm

Torque: Panel roof sill to body, 5 Nm

Torque: Window to power window mechanism (rear side door), 8 Nm

Torque: Window to power window mechanism (front side door), 8 Nm

Torque: Rear seat backrest to body , 40 Nm

Torque: Seat cushion rear to body, 25 Nm

Torque: Exterior handle to tailgate/luggage compartment lid, 5 Nm

Torque: Drier filter, 11 Nm

Torque: Distortion sensor to seat, 40 Nm

Torque: Bracket to front fender, 6 Nm

Torque: Bracket to front end, 6 Nm

Torque: Fitting bolt, hinge, 18 Nm

Torque: Hinge bracket to backrest, 9 Nm

Torque: Backrest cushion to seat cushion , 45 Nm

Torque: Burner unit to control module, 7 Nm

Torque: Console for shoulder back cushion backseat, 25 Nm

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.