Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2013XC60 AWD L6-3.2L VIN 95 B6324S5REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONPINOUT VALUES AND DIAGNOSTIC PARAMETERSSIGNAL SPECIFICATION, ENGINE CONTROL MODULE (ECM)
2013 Volvo XC60 AWD L6-3.2L VIN 95 B6324S5
Signal Specification, Engine Control Module (ECM)
2013 Volvo XC60 AWD L6-3.2L VIN 95 B6324S5SECTION Signal Specification, Engine Control Module (ECM)
Signal specification, engine control module (ECM)
All values indicated below are between respective connection in column 2 and column 1 (on the breakout box). If this is not the case, it is indicated within brackets.
Connector A (96-pin) corresponds to terminals #A1 - #B36 on the breakout box.
Connector B (58-pin engine side) corresponds to terminals #C1 - #58 on the breakout box.
Note! Connect the breakout box and check the ground connections before starting to measure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.