Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2013XC60 AWD L6-3.2L VIN 95 B6324S5REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYTESTING AND INSPECTIONPINOUT VALUES AND DIAGNOSTIC PARAMETERSSIGNAL SPECIFICATION, KEYLESS VEHICLE MODULE (KVM)
2013 Volvo XC60 AWD L6-3.2L VIN 95 B6324S5
Signal Specification, Keyless Vehicle Module (KVM)
2013 Volvo XC60 AWD L6-3.2L VIN 95 B6324S5SECTION Signal Specification, Keyless Vehicle Module (KVM)
Signal specification
General
All values given below are between the terminals stated in column 1 and terminal #B4 (power ground). This applies unless otherwise indicated in brackets.
Note! It is important to connect the breakout box and check the ground terminals before taking readings.
Connector C1
Connector C2
Connector C3
Connector C4
Connector C5
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.