Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2013XC60 AWD L6-3.2L VIN 95 B6324S5REPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYSPECIFICATIONS
2013 Volvo XC60 AWD L6-3.2L VIN 95 B6324S5
Keyless Entry: Specifications
2013 Volvo XC60 AWD L6-3.2L VIN 95 B6324S5SECTION Specifications
Component specification
Outer antennas in rear door handle (3/275-276) and outer rear antenna (16/132)
General
Type
SPOL antennas
Characteristic
Resistance depends on outside temperature and the length of the cables in the vehicle. A guide value is approx. 10-30 ohms.
Resistance in the antenna should be 0 ohms or infinite.
Other information
Option.
Terminal
Check
Prerequisites (unless otherwise specified):
- Breakout box connected.
- Antenna connected
Check
Antenna
Measure the resistance between the antenna connections
The value should be 10-30 ohms.
The antennas can also be checked using a function in the control module.
Internal antennas in the passenger compartment
General
Type
SPOL antennas
Characteristic
Resistance depends on outside temperature and the length of the cables in the vehicle. A guide value is approx. 10-30 ohms
Resistance in the antenna should be 0 ohms or infinite.
Other information
Option.
Terminal
Terminal
Check
Prerequisites (unless otherwise specified):
- Breakout box connected.
- Antenna connected
Check
Antenna
Measure the resistance between the antenna connections
The value should be 10-30 ohms.
The antennas can also be checked using a function in the control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.